Button application is very wide, especially ordinary, some of the clothes we wear, see so many beautiful buttons, many people want to know how the button is made in the end? Here China's button industry network Xiaobian to talk about Button making process and some related precautions. 1) The shape of the surface of buttons, most of them are hand-grinding styling knives on button shapes. The disadvantage is the same shape, the same model, when the quantity is large, the shape is easy to run off, which depends on the responsibility of the buckle technician. Responsible and qualified technicians can do a good job. Then there is a sharpening machine. If the number is large, it will be very good and it will not run. However, when setting up the knife, it is also necessary to pay attention to the distance between the surface and the left and right sides. The tool holder is not very delicate and has clearance. 2) The thickness of the button edge, a button's edge we pay attention to not, the same batch of goods are thick and thin, there is no unity, this is related to the problem of the responsibility of the deduction machine chuck and technician, when the chuck adjustment I saw the fastener technicians in the deduction factory. After adjusting the outside of the machine, after installing the machine, most of them did not adjust. In fact, although the collet has been adjusted, after the machine is installed, it still needs to be adjusted. Since -1) Did you have the grease on the chuck when you installed it? Do you have any errors in the part of your machine? 3) Did you install the machine's clamping head, is there no dirt in it? So even if the button clip is installed, you still need to be responsible for the uniform thickness of each button, and the adjustment needs to be adjusted. To ensure the uniform thickness of buttons. When the button is installed, the unit is OK and the button is adjusted (thickness, edge, shape, eye distance). When you start production, please put a few OKs next to the button machine, because these buttons are It is often the case that large goods are produced at a later time. When starting to produce large goods, these buttons are used to come to an end. When deductions are made, buttons are often used to see the buttons. When using common calipers, the quantity is used for comparison. The quality of a batch of buttons. 4) When deducting the tool, it depends on the responsibility of the deduction technician. The general deduction technician is lazy and sharp. It does not seem to be his own. He can't survive, and he can't stretch it. Grind it. Hey, now. How many people like this, ah, buckle technicians should look at the buttons in the system, found that the tool is blunt, immediately sharpening, the button too hair, then affect the overall quality of the button, and beautiful, and may become obsolete. There are also requirements for the scraping of the buttons, and the low scraping should also be controlled. Do not scratch it. The low arc must follow suit. During the deduction process, we must look more, use more calipers, compare the appearance of the caliper, and find that the problem is immediately resolved. Do not wait until the button reaches the finished product. Only afterwards find out what the problem is. Waste of manpower, financial resources, and delivery date. Want to learn more about buttons: accessible For more details, please pay attention to WeChat public number: Cable Insulation Tape,Pure White Non Woven Tape For Cable,Polyester Fabric Water Blocking Tape,Strengthened Light Weight Non Woven Fabric Jiangsu Super Prosperous New Material Co., Ltd , https://www.jschaowang.com